The `Flying Barrel`.....Limped over the line!!

Thanks very much indeed Mark

Cheers Robbo..........the yellow continues under the very front wing for about 3-4mm in and runs the full width ...the rest of the wing is kept Alu so it was a simple case of running Tam tape along it`s front span.

The top wings are fitted first onto the rigid spars and allowed to dry this gives a solid base to work with when putting it all together............the `N` posts and lower wings are attached afterwards and while the glue is still pliable you can align as necessary against a rigid surface.........by going the other way you would be putting pressure on only the wing attachment points where it joins the fuselage which is a lot weaker than the rigid upper wing............and thats how they tell you to do it in the instructions anyway .......but it makes sense

All the painting was done prior to fitting so access wasn`t a prob

I`m determined to get a wingy under my belt so this is alive.........hope to get somat up later

I would never had guessed, that this what you was on about yesterday .
Looking forward to this one coming back Boots

WHAT?

Because I'm

Now that looks superb! I agree mate a light bit of panel washing will be just the job on this.

Thanks Pete and Paul

She`s had another gloss coat to seal the decs and i`ll leave this to sit for 24hrs so the gloss cures before adding some pin/panel wash etc

Thanks Guybro ............might do an underneathy bit first just in case