Post by NEMO on Feb 12, 2018 18:39:55 GMT
Okay this one's done.....
Final assembly consisted of adding the foam hoses from the manifolds to the nozzles: 2.5mm heat shrink tube was used with 1mm rod added internally to allow the bends without folding. Where the hoses meet the manifolds, pewter foil was wrapped around the connections.
The hull had some dirt added to the lower reaches using heavily thinned LC Polish Uniform
Superstructure was CA'ed in place
Remote unit was fitted to the hull sponson and attached to the cabin by cable. Additional ladder was fitted to the Port side brackets and the safety cage fitted to top things off.
A thoroughly enjoyable build and one that's been loitering on my To Do list for some years!
Here be pictures including a comparison with the Madill Yarder for a 'size off'......
Thanks to everyone for following, your support is appreciated as ever.....
Final assembly consisted of adding the foam hoses from the manifolds to the nozzles: 2.5mm heat shrink tube was used with 1mm rod added internally to allow the bends without folding. Where the hoses meet the manifolds, pewter foil was wrapped around the connections.
The hull had some dirt added to the lower reaches using heavily thinned LC Polish Uniform
Superstructure was CA'ed in place
Remote unit was fitted to the hull sponson and attached to the cabin by cable. Additional ladder was fitted to the Port side brackets and the safety cage fitted to top things off.
A thoroughly enjoyable build and one that's been loitering on my To Do list for some years!
Here be pictures including a comparison with the Madill Yarder for a 'size off'......
Thanks to everyone for following, your support is appreciated as ever.....
