Sherman M4A3....Huuuu`bloody`raaahhh!!

Yes i know it resembles the starting grid of a mini Moto GP race but the parts are sorted into their relevant sequence

I then added some texture to the rubber road wheels using my special texture adding technique

Here`s a before and after pic...

All i do is layout a small sheet of sand paper, then i run some glue around the outer edge and roll it back `n` forth over the sand paper while the glue is wet..........it dries in seconds and leaves a nice pattern on the rubber rather than being silky smooth which i doubt it would be in real life..........i also cut out some nicks for wear and tear

Also made up the drives and idlers plus the rear end plate and gubbins..........the back plate for the sussies has been glued in place so as to get all the wheels etc level.........i`ll paint and add the front parts along with the wheels separately to make life easier and fit them later

More soon as...cheers chapsies